Manual Wireless Beehome

be set to 1. 2. This can be used to set the frequency (address) of the transmitter (there are 8 options). 3. Is never modified (is always set to 2). 4. [...] address (see above for instructions on how to set the address/frequency) will have to be installed in the aisle. In order to prevent signal interference, the [...] mechanisms are open. From that moment, the receiver will await a command from the transmitter. If this command was already given earlier in the day, the receiver

Natutec_Airobreez_-_Directions_for_Use_-_Koppert.pdf

Duct. Refer to section 7.3.1. Bucket ring. Refer to section 7.3.3. Reservoir. Refer to section 7.3.5. 25 Maintenance 7.3 Remove and install procedures [...] correctly. Refer to section 7.3.3. One or more clamps are attached incorrectly. Attach the clamps correctly. Refer to section 7.3.7. The lid is turned [...] product from the reservoir. Refer to section 6.3.4. 2. Clean the device. Refer to section 7.2. 3. Wind the strap around the device or remove it from the device